- 53 -
Installing the Device
AppendixPrinting
3
Setting Up
2
Before use
1
Basic Device Operations
4
Index
5
Rotate the nuts and bolts at the bottom
of each foot to lower the feet.
6
When each foot has reached the
ground, tighten the nuts at the top to
secure the tray unit.
Note
When moving the device, rotate and thoroughly lift the
screws on the feet of the large-capacity expansion tray
unit, and move while remote from the ground.
Memo
If mounting the expansion tray unit, it is necessary to implement
“Connecting Cables” (P.63)
and
“Connecting Power
Cables” (P.57)
before making the settings for the printer
drivers to detect the expansion tray unit.
See
“Adding Options” (P.82)
.
If moving the printer or replacing consumables
or maintenance units, or setting paper in the
tray, check the following points to prevent the
printer from toppling.
Do not press the front cover when the printer
font cover is open.
Do not press on the cassette from above when
the cassette is pulled out.
To Next Page
Loading...
Need help?
General
