145
Numeral Setting
Section 4-8
4-8-4 Using Numeric Keys
To input numerical data by using numeric keys, first select the numeral setting area
into which the value is to be input, then input the numerical value by pressing the
appropriate numeric keys.
Selecting the Numeral Setting Area for Data Input
Select the numeral setting area into which the numerical value is to be input by
using either the numeric keys or the system keys.
S Selection with the numeric keys
Use the [HOME], [→], [←], [↑] and [↓] keys. By using these keys, the cursor can
be shifted between numeral setting areas in the way shown in the figure below.
6563
4568
5107
3200
0000
4624
HOME
→
↑
↑
←
Pressing the [HOME] key will shift the cursor to the area whose top left corner
has the smallest XY coordinate sum (the top left numeral setting input field in the
example above).
S Selection with the system keys
When the and system keys on the touch panel are pressed, the cursor
moves between the numeral setting areas by following the order in which they
were created using the support tool.
For example, if three numeral setting areas have been created, the cursor can
be moved between them following the order of creation as follows.
key:1st area → 2nd area → 3rd area → 1st area
key:1st area → 3rd area → 2nd area → 1st area
If the “numeral setting” screen attribute is set to “system”, the order of cursor
motion when the and system keys are used can be changed. For details,
refer to the NT series support tool operation manual (V028-E1-j).
To Next Page
Loading...
Need help?
General
