Omron NT20S User Manual

11
System Configuration
Section 1-3
1-3-2 NT Link (1:N) Systems
When NT20S is connected to a PC in a 1:N connection, use an RS-232C cable and
RS-422A/485 cables.
OMRON PC
While controlling machinery and monitoring lines,
controls the NT20S when necessary.
C200H/HG/HE can be used.
C200HX/HG/HE
RS-232C cable
(max. length: 2 m)
RS-232C/RS-422A converter
unit, type NT-AL001
RS-422A/485 cable (

) RS-422A/485 cable (

)
RS-232C/RS-422A converter
unit, type NT-AL001
RS-232C/RS-422A converter
unit, type NT-AL001
(

) Total cable length: 500 m
RS-232C cable
(max. length: 2 m)
RS-232C cable
(max. length: 2 m)
NT20S
In an NT link (1:N), up to eight NT20S units
can be connected to one PC port.
NT20S
Apart from monitoring
production lines and
displaying instructions
on site, also notifies
switch ON/OFF
statuses and numerical
inputs to the PC.
Support tool
Computer (support tool)
Connected to an NT20S as required, to transmit
created NT20S screens and set NT20S settings.
Computer :IBM PC/AT or compatible
Support tool :NT-ZA3AT-EV2
Reference: When connecting the C200HX/HG/HE and an RS-232C/RS-422A converter unit,
use a converter unit whose lot number is 15Y5 or later. Converter units of lot num-
bers previous to 15Y5 cannot be connected.

Omron NT20S Specifications

General

Brand	Omron
Model	NT20S
Category	Touch terminals
Language	English