To Next Page

To Previous Page

Operation Flow by the System Menu

Section 3-1

3-1 Operation Flow by the System Menu

Follow the procedure below when using the NT20S for the first time or when

changing the system.

Create the Screen Data Create the screen data to be displayed on the NT20S by using a support tool.

For the screen data creation, refer to the “NT-series Support Tool Operation Manu-

al” (V028-E1-j).

Start Up the NT20S (Display the System Menu.) (page 68)

Turn ON the power to the NT20S.

When no screen data has been registered, the “SYSTEM MENU” will be dis-

played. If the NT20S enters the RUN mode, press appropriate touch switches to

display the System Menu.

Initializing Memory (page 72)

Select a System Menu and initialize the NT20S unit memory.

Memory Switch Settings (page 75)

Select the System Menu and make settings such as the communication conditions

for communication with the Host by setting the memory switches.

Registering the Screen Data (page 86)

Connect a support tool to the NT20S and transfer the screen data from the support

tool to the NT20S.

For the connection of a support tool, refer to Section 2-3 Connecting to the Support

Tool. (page 31)

Starting the Operation (page 90)

Connect to the PC/Host and start the operation.

System Maintenance (page 99)

If an error has occurred during operation, check the I/Os, settings, etc. referring to

this guide.

Omron NT20S User Manual

Questions and Answers: