4-5
4-1 Installation Conditions
OMNUC G5-SERIES AC SERVOMOTOR AND SERVO DRIVE USER'S MANUAL
4
System Design
Depending on the environment, such as when the Servomotor is installed near a heating element,
the Servomotor temperature may rise significantly. In this case, take any of the following
measures.
Lower the load ratio.
Review the heat radiation conditions of the Servomotor.
Install a cooling fan and apply forced air cooling to the Servomotor.
Other Precautions
Take measures to protect the motor shaft from corrosion. The motor shaft is coated with anti-
corrosion oil when shipped, but anti-corrosion oil or grease should also be applied when
connecting the components that apply load to the shaft.
Caution
Never repair the Servo Drive by disassembling it.
Electric shock or injury may result.
Do not apply a commercial power supply
directly to the motor. Failure may result.
To Next Page
Loading...
Need help?
General
