Omron SMARTSTEP A Series User Manual

Chapter 2
2-69
Standard Models and Specifications
5. Servo Phase-B Selectors (Not Used)
Leave these selectors set to INC mode.
■ Wiring to Screwless Clamp Terminal Blocks
Screwless clamp terminal blocks enable wiring without securing the wires with screws. Special fer-
rules must be attached to the cables for sensors or external devices if sensors or external devices
are also to be connected when wiring the Servo Driver and the control signal.
The following ferrules are applicable.
● Wiring Procedure
Inserting a Wire
Fully insert the ferrule all the way into the desired terminal hole.
Releasing a Wire
Insert a small flathead screwdriver into the release button above the terminal hole, and pull out the
wire while pressing the button.
Manufacturer Model Applicable wire
Phoenix Contact AI-0.5-10
0.5 mm
2
(20 AWG)
AI-0.75-10
0.75 mm
2
(18 AWG)
AI-1.5-10
1.25 mm
2
(16 AWG)
Nihon Weidmuller H 0.5/16 D
0.5 mm
2
(20 AWG)
H 0.75/16 D
0.75 mm
2
(18 AWG)
H 1.5/16 D
1.25 mm
2
(16 AWG)
Servo #2 phase-B
selector servo2
ABS_CW-
INC
SW7
SW8
Servo #1 phase-B
selector servo1
ABS_CW-
INC
Small flathead screwdrive
r
Release button

Omron SMARTSTEP A Series Specifications

General

Brand	Omron
Model	SMARTSTEP A Series
Category	Servo Drives
Language	English