Parkside PLEM 50 C4 - Addition and Subtraction

PLEM 50 C4
■ 20
│
GB
│
IE
The corresponding line in the double Pythagoras symbol g
flashes for the individual measured values. Immediately after the third
measurement, the calculated length is shown in the result line s of
the display 1 and the corresponding line of the double Pythagoras
symbol g stops flashing. The individual measured values are
shown in the top three lines of the display 1.
Note: Please note that angular errors (not a right angle) will lead
to incorrect results. Ensure that the measured distances lie on a
plane (alignment).
Addition (plus)
♦ To add two individual values, take a measurement (length, area or
volume) so that a value is shown on the display 1.
♦ Press the Add/Subtract button
5 to start the addition (plus).
The plus symbol flashes in measured value line 3 a on the
display 1.
♦ Take a second measurement (length, area or volume). The second
measured value will be shown in measured value line 3 a on the
display 1. Immediately after the second measurement, the result
of the addition is shown in the result line s of the display 1. The
first measured value will be shown in measured value line 2 p on
the display 1.