Setting up
29
9.06 Selecting a seam program
To avoid the machine starting accidentally, to begin with the TE key must be pressed, af-
ter the machine has been switched on. The machine is then in its basic position and offers a
number of possibilities for selecting seam programs.
- Direct selection of the seam pattern and its individual adaptation by changing the speed
and size factors.
- Selection of the seam program via a program station. For this purpose a seam pattern with
its respective speed and corresponding size factors must have been stored previously.
- With the selection of a sequence several seam programs are sewn after each other. For
this purpose a sequence must have been compiled beforehand from individual seam pro
grams (program stations).
9.06.01 Selecting and changing the seam pattern.
With the machine in the basic position, select the direct seam pattern.●
X Y
11 2700 100 100
With the corresponding +/- key select the desired seam pattern, e.g. 11. The seam pat-
terns are stored in the machine under program numbers, see Chapter 11.05 Summary of
the seam patterns.
Select the desired speed with the corresponding +/- key.
Enter the desired size factor (in %) (X-direction) with the corresponding +/- key.
Enter the desired size factor (in %) (Y-direction) with the corresponding +/- key.
Conclude the input by pressing the TE key. (The machine changes to the sewing mode).
The enlargement of the seam pattern is limited by the size of the machine’s se-
wing area.
The altered speed and size factors entered are not stored when the machine
changes to another seam program. If you wish to store these values, a station
key must be reserved with the corresponding seam program, see Chapter 11.01
Reserving program stations.
●
●
●
●
●
X
Y
To Next Page
Loading...
Need help?
General
