Care and maintenance
64
12 Care and maintenance
12.01 Maintenance intervals
Clean the entire machine ................................................................................. once a week
Clean the hook compartment ..........once a day, more often when in continuous operation
Oiling the needle head parts ............................................................................... as required
Oiling the hook ....................................................................................................as required
Oiling the bearing points in the arm ................................................................once a month
During all cleaning work the machine must be disconnected from the power
supply by switching off the main switch or pulling out the plug!
Danger of injury if the machine is started accidentally!
12.02 Cleaning the machine
The cleaning cycle required for the machine depends on following factors:
Single or several shift operation
Amount of dust resulting from the workpiece
It is therefore only possible to stipulate the best possible cleaning instructions for each indi-
vidual case.
For all cleaning work the machine must be disconnected from the mains by
switching off the on/off switch or by removing the mains plug!
Danger of injury if the machine suddenly starts up
To avoid breakdowns, the following cleaning work is recommended for single shift operation:
Clean hook compartment and needle area of sewing head several times daily.
Clean the entire machine at least once a week.
●
●
●
●
To Next Page
Loading...
Need help?
General
