Input
38
11 .02 Sequences
11
.02.01 Entering sequences
The sequence program keys C1 to C3 are used to enter and select sequence programs. The
sequence programs are put together from seam programs, which have been deposited un-
der the station keys P1 to P8.
A sequence can consist of up to 3 segments (A, B + C). In each segment up to
14 entries can be made.
Call up the input mode by pressing the TE key (LED is illuminated).
In the input mode, select the desired sequence program key, e.g. C2.
Enter the desired seam programs in any order by using the station keys, e.g. P3 six times ,
P8 four times,
P4 twice
Press the TE key input twice (machine changes to the sewing mode).
●
●
●
A 3 - 3 - 3 - 3 - 3 - 3 - 8
8 - 8 - 8 - 4 - 4
to
The station keys for selection must have been reserved beforehand, see
Chapter 11.01 Reserving program stations.
In the "Input" mode it is possible to scroll between the sequence zones
A, B and C by pressing the Menu key.
2x
11.02.02 Checking the sequence contents
With the machine in its basic position, select the desired sequence, e.g. C2.
The activated sequence point fl ashes.
Press the corresponding +/- key to move to the sequence point to be checked (e.g. 8).
●
●
●
To Next Page
Loading...
Need help?
General
