Connecting additional devices
You can connect additional devices such as decoders, satellite receivers, camcorders, etc. to the
S-VIDEO (Y/C), VIDEO (CVBS), COMPONENT VIDEO Y PB PR and the L AUDIO R,
AUDIO jacks on the recorder, Switching between jack S-VIDEO (Y/C) and VIDEO (CVBS) is
done automatically,
The DVD recorder must be connected directly to the TV set (S-VIDEO (Y/C) OUT,
VIDEO (CVBS) OUT, or COMPONENT VIDEO Y PB PR OUT socket directly to the TV
set), If there is a video recorder in between the picture quality may be poor because of the copy
protection system built into the DVD recorder.
Can I also connect other devices with 'Progressive scan'?
Tile COMPONENT VIDEO Y PB PRjacks are only used for
'interlaced' signals. Signals using progressive scan cannot be processed by
the DVD recorder.
?
Connecting an additional video recorder,
DVD player
You can also connect a video recorder or a DVD player to the input jacks. Please use the
S-VIDEO (Y/C) jack and the L AUDIO R jacks for SVHS video recorders,
Please be aware
Most pre-recorded video cassettes and DVDs are copy protected. When you attempt to copy
,rnn_, o_n T,
them, the Lu, J F Fu message will appear in the DVD Recorder display,
xWhen copying video cassettes '_ _,'_NfYL' appears in the
DVD Recorder display
"/ Check whether the cable plugs fit correctly.
¢" If the recording is made from a video recorder, adjust the "tracking"
on the video recorder.
¢" In case of bad, non-standard video input signals, the DVD Recorder
may not be able to detect the signal.
xWhen copying from DVDs or pre-copied video cassettes, the
picture is grainy and the brightness fluctuates.
¢" This occurs when you attempt to copy copy-protected DVDs or
video cassettes. Although the picture on the TV is OK, the recording
is distorted on a DVD+R(W). Copy-protected DVDs and video
cassettes cannot be copied without these disruptions.
Problem
18 Connecting additional devices
To Next Page
Loading...
Need help?
Picture/Display
Power
