Remote seat opening
The vehicle is equipped with a remote control to open the saddle.
This remote control is supplied together with the keys and at the manufacturing stage, it has been
programmed to work together with the ECU that control the opening device.
If the remote control is lost, a new one can be requested and reprogram it by resetting the ECU memory
and following the same steps as per programming the immobilizer system in the keys.
Battery replacement
To separate the two half-shells of the remote con-
trol, insert a blade or a very thin tip of a screwdriver
into a point of the outside edge, then let it slide
along the entire circumpherence.
- Access the printed circuit and remove the two
batteries from the contact reed.
- Place the new batteries with the positive pole
facing the contact reed.
Characteristic
Batteries used:
CR1616
- Replace the card on the rear half-shell with the
button and the led facing outwards.
- Install the pressure rubber on the button (the di-
rection of installation is only one)
- Make the other half engage snap-wise.
Zeroing
- Remove the metal terminal by pliers and connect
it to earth or to terminal 7 (black), for at least 10
seconds.
- This operation clears all remote controls stored
in the control unit.
N.B.
THE CONTROL UNIT CAN PROGRAMME UP TO 7 REMOTE
CONTROLS.
Electrical system X9 Evolution 500
ELE SYS - 82
To Next Page
Loading...
Need help?
General