PIAGGIO MP3 400 i.e. User Manual

Front
- The operations described refer to only one cal-
liper but are valid and must be observed for both.
- Remove the rubber hood from the bleed screw.
- Insert a rubber pipe in the bleed screw to permit
the brake fluid to be recovered.
- With the right-hand brake lever, load the system and bring it up to the required pressure.
- Keeping the right-hand brake lever pulled, loosen the bleed screw to permit the air in the system to
escape. Then tighten the bleed screw.
- Repeat the operation until only brake fluid comes out of the rubber pipe.
- Remove the fluid recovery pipe and refit the rubber hood over the bleed screw.
- Top up the brake fluid to the right level in the tank.
N.B.
DURING THE BLEEDING OPERATIONS, MAKE SURE THE BRAKE FLUID DOES NOT COME INTO
CONTACT WITH THE BODYWORK SO AS NOT TO DAMAGE IT. FURTHERMORE, DURING THE
BLEEDING OPERATIONS REGARDING THE BRAKE CALLIPERS, MAKE SURE THE BRAKE
FLUID DOES NOT COME INTO CONTACT WITH THE DISC BRAKES AND WITH THE BRAKE
PADS. FAILURE TO COMPLY WITH THIS NORM WILL ENDANGER THE PROPER WORKING AND
EFFICIENCY OF THE BRAKING SYSTEM
If necessary, bleeding can be done using a special vacuum pump
Specific tooling
020329Y MityVac vacuum-operated pump
Locking torques (N*m)
Oil bleed screw 8÷12
Brake pipes
Front brake pipes removal
Unscrew the braking splitter screw.
Disconnect the brake pipes removing the two met-
allic straps indicated in the figure.
Remove the brake oil tube fitting from the rigid pipe
inside the front suspension arm and loosen the
hydraulic joint fixing nut of the suspension locking
to release the brake pipes.
Braking system MP3 400 i.e.
BRAK SYS - 12

PIAGGIO MP3 400 i.e. Specifications

General

Brand	PIAGGIO
Model	MP3 400 i.e.
Category	Scooter
Language	English