Carry out the listed tests before delivering the vehicle.
Warning- be very careful when handling fuel.
Position the plastic cover supplied with the cou-
pling on the steering tube as shown in the figure.
If a customer wishes to have mudflaps installed,
proceed as follows:
•
Place the flap in the mudguard inner
side as shown in the figure, making the
4 securing holes coincide.
•
Fit the 4 washers on the mudguard out-
er side and, always on the same side,
insert the 4 screws and tighten to the
prescribed torque.
Locking torques (N*m)
mudflap insert fixing screws 2 ÷ 3
Aesthetic inspection
Appearance checks:
- Paintwork
- Fitting of plastics
- Scratches
- Dirt
Tightening torques inspection
Lock check
- Safety locks
- clamping screws
Safety locks
•
Rear shock absorber upper fixing
•
Rear shock absorber lower fixing
Pre-delivery MP3 400 i.e.
PRE DE - 2
To Next Page
Loading...
Need help?
General