a few minutes and switch it off: after five minutes
check the level and if necessary top up without
exceeding the MAX level. The cartridge filter must
be replaced every time the oil is changed. Use new
oil of the recommended type for topping up and
changing purposes.
N.B.
THE ENGINE MUST BE HOT WHEN THE OIL IS
CHANGED.
Recommended products
AGIP CITY HI TEC 4T Engine oil
SAE 5W-40 Synthetic oil that exceed the require-
ments of API SL, ACEA A3, JASO MA specifica-
tions
Locking torques (N*m)
Engine oil filter 12 - 16 Engine oil drainage
plug 24 ÷ 30
Check
This operation must be carried out with the engine
cold and following the procedure below:
- Place the vehicle on its centre stand and on flat
ground.
- Unscrew the cap/dipstick "A", dry it with a clean
cloth and reinsert it, screwing it all the way
down.
- Remove the cap/dipstick again and check that
the level is between the min and max reference
marks; top up, if required.
If the check is carried out after the vehicle has
been used, and therefore with a hot engine, the
level line will be lower; in order to carry out a cor-
rect check, wait at least 10 minutes after the en-
gine has been stopped so as to get the correct
level.
Maintenance MP3 400 i.e.
MAIN - 10
To Next Page
Loading...
Need help?
General