4.3
FUEL INJECTION
4
Digital WrenchDiagnostic Software - PU-47063
This dealer-only software installs on laptop computers equipped
with a CD drive and serial port connection, and is designed to
replace multiple shop tools often used to test EFI components.
It also includes step-by-step diagnostic procedures to aid
technician repair and troubleshooting.
Digital Wrenchîš•
SmartLink Module Kit - PU-47471
This module kit contains the necessary cables and hardware to
communicate between the vehicle ECU and the Digital
Wrenchâ„¢ diagnostic software. Polaris dealers can also order
the following separately: SmartLink Module PU-47468,
Vehicle Interface Cable PU-47469 and PC Interface Cable
PU-47470. This module kit is used on all 8 pin connector-based
Polaris EFI systems. This kit is available to Polaris dealers
through our tool supplier, SPX (1-800-328-6657).
Digital Wrench- Diagnostic Connector
(Located under the hood as shown below)
Throttle Position Sensor Tester - PU-47082
This tester allows the use of a digital multi-meter to test TPS
function as well perform initialization procedures.
Throttle Body Adjustment Screwdriver
PU-47315
This tool has a special ‘D’ shaped end for adjusting the throttle
stop screw during a TPS initialization procedure.
PU-47468
PU-47469
PU-47470
To Next Page
Loading...
Need help?
General
