Polaris 2008 ranger 700 xp Service Manual

3.14
ENGINE
Recommended Coolant
Use only high quality antifreeze/coolant mixed with distilled
water in a 50/50 or 60/40 ratio, depending on freeze protection
required in your area.
CAUTION: Using tap water in the cooling system will lead to
a buildup of deposits which may restrict coolant flow and reduce
heat dissipation, resulting in possible engine damage. Polaris
Premium 60/40 Antifreeze/Coolant is recommended for use in
all cooling systems and comes pre-mixed, ready to use.
Cooling System Pressure Test
1. Open front hood.
2. Remove surge tank hose from coolant filler neck.
3. Connect a Mity Vac
 (PN 2870975) to the filler neck
nipple and pressurize system to 10 psi. The system must
retain 10 psi for five minutes or longer. If pressure loss is
evident within five minutes, check the radiator, hoses,
clamps and water pump seals for leakage.
Radiator Cap Pressure Test
1. Remove radiator cap and test cap using a commercially
available cap tester.
2. The radiator cap relief pressure is 13 psi. Replace cap if it
does not meet this specification.
Radiator
Water
Pump
Cylinder
Thermostat
Cylinder
Head
WARNING
Never remove radiator cap when engine is
warm or hot. The cooling system is under
pressure and serious burns may result.
Allow the engine and cooling system to cool
before servicing.
Radiator Cap
Coolant Flow Diagram
To Water Pump
Radiator
Surge Tank
From
Thermostat Housing

Polaris 2008 ranger 700 xp Specifications

General

Brand	Polaris
Model	2008 ranger 700 xp
Category	Automobile
Language	English