Polaris 2008 ranger 700 xp Service Manual

10.6
ELECTRICAL
Parking Brake Switch
The parking brake switch is located under the dash or under the
hood. Follow the parking brake lever under the dash to locate the
switch.
The switch remains in the “open” position when the park brake
lever is not applied.
The switch makes contact when the park brake is applied and
sends voltage to the ECU and Speedometer to illuminate the
“Park Brake Indicator” near the top-center of the instrument
cluster.
TESTING PARK BRAKE SWITCH
1. Disconnect the Orange/Red wire and Red/White wire from
the switch.
2. Place the ohmmeter leads onto terminal leads A and C. The
reading should be infinite (•).
3. Apply the parking brake. There should be continuity
between the switch terminals. If no continuity exists when
the park brake is applied, try to clean the switch terminals
and re-test. Replace switch if necessary.
Parking Brake Switch
Parking Brake
Not Applied
Parking Brake
Applied
RD/WH
OG/RD
Key-On
Power
P
Park Brake
Indicator

Polaris 2008 ranger 700 xp Specifications

General

Brand	Polaris
Model	2008 ranger 700 xp
Category	Automobile
Language	English