Polaris 2008 ranger 700 xp Service Manual

7.55
FINAL DRIVE
7
Axle Tube Bearing Replacement
1. Remove the retaining ring from the axle tube.
2. Remove the bearings from the axle tube with a bearing
puller. Inspect the bearing contact surfaces in the axle tube.
3. Install the new bearing using a press.
NOTE: The bearing should be properly lubricated
before installation.
4. Reinstall the retaining ring.
Gearcase Disassembly / Inspection
1. Drain and properly dispose of used oil.
2. Remove the differential housing cover bolts and the
gearcase housing cover.
3. Remove the shim and O-ring from the differential cover.
4. Remove the output shaft and ring gear from the differential.
Inspect the ring gear for abnormal wear, broken, or chipped
teeth. Inspect the bearings for wear. Spin the bearings by
hand, the bearings should roll smoothly. Replace the
bearings if needed.
Shim
O-Ring
Bearings

Polaris 2008 ranger 700 xp Specifications

General

Brand	Polaris
Model	2008 ranger 700 xp
Category	Automobile
Language	English