Polaris 2008 ranger 700 xp Service Manual

8.4
TRANSMISSION
4. Disconnect the transmission switch.
5. Remove the cotter pin from the shift linkage rod. Remove
the shift linkage rod and a washer from the bellcrank.
6. Loosen the jam nuts for the transmission cable. Remove the
cable from the mounting bracket.
7. Remove the mounting bolts from the transmission
mounting on both sides of the transmission.
8. Remove the four bottom transmission to frame bolts.
9. Remove the rear transmission to frame bolt.
10. Remove front transmission-to-engine mount bolt.
11. Remove transmission from right side of frame.
Transmission Switch
Jam Nuts
General Transmission Mounting

Polaris 2008 ranger 700 xp Specifications

General

Brand	Polaris
Model	2008 ranger 700 xp
Category	Automobile
Language	English