Polaris 2008 ranger 700 xp Service Manual

8.7
TRANSMISSION
8
14. Remove the shift forks from the assembly. Note the correct
position of each fork.
NOTE: The picture above depicts a transmission
with a “park dog” on the end of the shaft instead of a
regular “shift dog”. The transmission will have a
regular shift dog in the location indicated by the
arrow in the photo.
15. Remove the bearing from the reverse shaft with a puller.
16. Remove the park lock engagement dog. Remove the wave
spring and reverse engagement dog.
17. Remove the bearing from the input shaft with a puller.
18. Remove the snap ring and washer from the reverse shaft.
19. Remove low gear (33T) and the needle bearing.
20. Remove the reverse gear shaft.
Shift Fork
Engagement
Dogs

Polaris 2008 ranger 700 xp Specifications

General

Brand	Polaris
Model	2008 ranger 700 xp
Category	Automobile
Language	English