3.32
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
22. Loosen the hose clamp (F) securing the throttle body
to the air box. Lift air box up and rearward as an
assembly to disengage it from the throttle body.
23. Loosen the hose clamp (G) securing the throttle
body to the engine intake boot. Remove throttle body
from the engine and wrap it with a clean shop towel.
Place throttle body on the left-hand side frame rail
area.
NOTE
Be sure dirt and debris do not enter the engine, air box
or throttle body. Use clean shop towels to plug engine
and air box intake holes.
24. Disconnect the upper engine coolant hose (H),
bypass hose (I) and ECT (J) harness connector.
25. Remove the three hex bolts (K) securing the exhaust
head pipe to the engine. Remove the two springs (L)
securing the muffler to the head pipe. Discard the
muffler and head pipe seals and replace with new for
reassembly.
26. Remove the head pipe assembly from the right-hand
side of the vehicle to gain engine removal clearance.
Removal of the muffler from the chassis is not
required.
27. Place a support in-between the main frame and
transmission case. Do not pinch brake line.
28. Use an overhead or portable engine hoist and
suitable engine straps to secure the engine in its
current position.
ENGINE / COOLING SYSTEM
To Next Page
Loading...
Need help?
General
