4
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
4.33
4. If the resistance is correct:
• Test the main harness circuit between the sensor
connector terminals and the corresponding pin
terminals at the ECU (see wiring diagram).
• Check the sensor mounting, air gap, flywheel encoder
ring for damage or runout, and flywheel key. Follow the
CPS Replacement, page 4.33 procedure to inspect
CPS and flywheel encoder ring for damage.
5. If the resistance is incorrect, follow theCPS
Replacement, page 4.33 procedure.
CPS REPLACEMENT
1. If not done already; disconnect the CPS harness
connector (see CPS Test, page 4.32).
2. Using an 8mm socket, remove the CPS retaining bolt
and remove the sensor from the stator cover.
3. Install new sensor using a light coating of oil on the
O-ring to aid installation.
4. Torque the CPS and heat shield retaining bolts (if
equipped) to specification.
TORQUE
CPS Retaining Bolt:
9 ft-lb (12 Nm)
FUEL SYSTEM
To Next Page
Loading...
Need help?
General
