11.12
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
SWITCHES / CONTROLS
IGNITION KEY SWITCH / HEADLAMP
SWITCH
1. Disconnect the key switch harness by lifting the
connector lock and pulling on the connector. Do not
pull on the wiring.
2. Test between the 4 sets of outputs (OFF / ON
LIGHTS / ON / START). If any of the tests fail,
replace ignition switch assembly.
• Move the switch “ON LIGHTS”. There should be con-
tinuity between pins A and E; C and D.
• Turn the ignition key to ON. There should be continuity
between switch pins C and D; E and F.
• Turn the ignition key to START. There should be con-
tinuity between switch pins A and B; C and D; E and F.
IGNITION KEY SWITCH (INTL)
1. Disconnect the key switch harness by lifting the
connector lock and pulling on the connector. Do not
pull on the wiring.
2. Test between the 4 sets of outputs (OFF / ON
LIGHTS / ON / START). If any of the tests fail,
replace ignition switch assembly.
• Turn the ignition key to ON LIGHTS. There should be
continuity between switch pins A, E and F; C and D.
• Turn the ignition key to ON. There should be continuity
between pins C and D; E and F.
• Turn the ignition key to START. There should be con-
tinuity between pins A and B; C and D; E and F.
ELECTRICAL