7.22
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
19. Install and tighten the small clamp
e
using the
appropriate clamp tool.
Axle Boot Clamp Tool: PU-48951
or
CV Boot Clamp Pliers: 8700226
20. Pull out on the drive shaft to center the joint in the
housing. Slide a straight O-ring pick or a small
slotted screw driver between the large end of the
boot and the joint housing and lift up to equalize the
air pressure in the boot.
21. Position the boot lip in its groove. Install and tighten
the large clamp
r
using the appropriate clamp tool.
Axle Boot Clamp Tool: PU-48951
or
CV Boot Clamp Pliers: 8700226
PROP SHAFT REMOVAL / INSTALLATION
1. Remove both seats and the engine service panel as
outlined in Chapter 5.
2. Disconnect the negative (-) battery cable.
3. Raise and support vehicle and remove the left-hand
rear wheel.
CAUTION
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure. Wear eye protection when removing
bearings and seals.
4. From the right-hand front wheel well, locate the
propshaft roll pin. Use the Roll Pin Removal Tool (PN
2872608) to remove the roll pin from the front
gearcase.
Roll Pin Removal Tool:
2872608
5. Remove the outer clutch cover, drive belt and drive
clutch as outlined in Chapter 6.
6. Disconnect the harness connector at the brake
switch. Remove the two screws securing the brake
line junction block and move the junction block
towards the left-hand frame rail.
7. Remove the gear selector cap and remove the
retaining screw and handle.
FINAL DRIVE
To Next Page
Loading...
Need help?
General
