8.18
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
6. After the new ball joint is fully installed into the A-
arm, install a new retaining ring.
7. Repeat the ball joint service procedure for any
additional A-arm ball joint replacements.
8. Insert upper / lower A-arm ball joint end into the
bearing carrier. Install new pinch bolts and nuts.
Torque to specification.
TORQUE
Front Ball Joint Pinch Bolts:
23 ft-lb (31 Nm)
9. If needed, install new brake caliper mounting bolts
and torque to specification.
TORQUE
Front Caliper Mounting Bolts:
30 ft-lbs (41 Nm)
CAUTION
New bolts have a pre-applied locking agent which is
destroyed upon removal. Always use new brake caliper
mounting bolts upon assembly.
10. Install wheel and four wheel nuts. Torque wheel nuts
to specification.
TORQUE
Wheel Nuts:
Steel Rims: 27 ft-lbs (37 Nm)
Aluminum Rims: 30 ft-lbs (41 Nm) + 90°
STABILIZER BAR LINKAGE REMOVAL
1. Elevate and safely support the front of the vehicle.
2. Remove the lower shock mounting fastener from the
upper A-arm on each side of the vehicle (see
“Exploded View”).
3. Remove the upper portion of the linkage from the
stabilizer bar on each side of the vehicle (see
“Exploded View”):
4. Inspect the linkage assemblies for signs of excessive
wear or damage. Replace linkage assembly if
damaged.
5. Reverse the procedure for installation. Torque the
linkage fasteners to specification (see “Exploded
View”).
STEERING / SUSPENSION
To Next Page
Loading...
Need help?
General
