7
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
7.15
9. Grasp the rear drive shaft and pull sharply outward
on the shaft to disengage it from the rear gearcase.
NOTE
Take care when removing to prevent damaging the
seal.
10. Inspect the axle splines and CV boots for any
damage.
REAR DRIVE SHAFT INSTALLATION
1. Install new spring ring on drive shaft. Apply anti-
seize compound to splines.
2. Align splines of drive shaft with rear gearcase and
reinstall the drive shaft. Use a rubber mallet to tap on
the outboard end of the drive shaft if necessary.
NOTE
Take care when installing the drive shaft to prevent
damaging the seal.
3. Slide the rear drive shaft into the rear bearing carrier.
FINAL DRIVE
To Next Page
Loading...
Need help?
General
