7.16
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
4. Lift bearing carrier into place and install the bolt
attaching the bearing carrier to the upper A-arm.
Torque fastener to specification.
TORQUE
Upper Rear Bearing Carrier Bolt:
40 ft-lb (54 Nm)
5. Apply grease to drive shaft axle splines.
6. Install rear wheel hub assembly, cone washers, and
hand tighten the castle nut. Install washers with
domed side out.
7. Install NEW brake caliper mounting bolts and torque
to specification.
TORQUE
Rear Caliper Mounting Bolts:
44 ft-lbs (60 Nm)
CAUTION
New bolts have a pre-applied locking agent which is
destroyed upon removal. Always use new brake caliper
mounting bolts upon assembly.
8. Torque wheel hub nut to specification and install a
NEW cotter pin. Tighten nut slightly if necessary to
align cotter pin holes.
TORQUE
Rear Wheel Hub Castle Nut:
110 ft-lbs (149 Nm)
FINAL DRIVE
To Next Page
Loading...
Need help?
General
