2.36
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
6. Inspect electrodes
w
for wear and carbon buildup.
Look for a sharp outer edge with no rounding or
erosion of the electrodes.
7. Clean with electrical contact cleaner only.
8. Measure gap with a wire gauge. Adjust gap
e
if
necessary by carefully bending the side electrode.
9. If necessary, replace spark plug with proper type.
CAUTION
Severe engine damage may occur if the incorrect spark
plug is used.
10. Install spark plugs and torque to specification.
Recommended Spark Plug:
2013-2014: Champion XG4YCX
2015 and later: NGK MR7F
TORQUE
Spark Plug:
9 ft-lbs (12 Nm)
11. Install spark plug wire into spark plug / engine.
12. Reinstall cargo box access panel.
13. Reinstall the (-) negative battery cable and driver’s
seat.
ENGINE TO FRAME GROUND
Inspect ground cable connections. Be sure they are
clean and tight.
The engine ground cable
q
runs from the upper starter
motor mounting bolt to the chassis ground terminal.
The Chassis ground
w
is located under the drivers seat,
near the starter solenoid.
MAINTENANCE
To Next Page
Loading...
Need help?
General
