4.30
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
TPS TESTER / REGULATOR
The TPS reading must be checked by using Digital
Wrench® Diagnostic Software.
TPS REPLACEMENT
NOTE
The correct position of the TPS angle on the throttle
body is established and set at the factory. If the TPS is
replaced or has been loosened it must be repositioned
to obtain the proper voltage reading.
1. Remove the drivers seat and disconnect the
negative (-) battery cable.
2. Remove the cargo box access panel. The TPS
sensor screws can also be accessed through the
right-hand rear wheel well area.
3. Disconnect the vehicle harness from the TPS.
4. Remove the two Phillips-head mounting screws and
replace the TPS. Reconnect the vehicle harness to
the TPS.
NOTE
If replacing the TPS or throttle body, you must set the
TPS voltage to specification.
TPS Adjustment Using Digital Wrench®:
5. Assemble SmartLink Module and connect the
diagnostic interface cable to the vehicle to allow
Digital Wrench® use (see Chapter 4 – Digital
Wrench® - Diagnostic Connector, page 4.40).
FUEL SYSTEM
To Next Page
Loading...
Need help?
General
