Polaris RZR 570 2015 Service Manual

5
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
5.9
12. Loosen hose clamp attaching the PVT inlet duct to
the inner clutch cover. Disengage hose from the
inner clutch cover.
13. Loosen the hose clamp (A) that attach the clutch
outlet duct to the inner clutch cover. Disengage the
hose from the cover.
14. Remove the eight bolts that retain the inner clutch
cover to the engine and transmission. Remove inner
clutch cover. Make note of cable and hose routings
for assembly.
PVT ASSEMBLY
1. Inspect inner clutch cover. Replace if cracked or
damaged.
2. Inspect the seal on the transmission input shaft.
Replace if damaged.
3. Remove silicone sealant from the engine case and
inner PVT cover.
4. Apply RTV silicone sealant to the back side of the
inner clutch cover to ensure a water tight fit between
the engine and inner clutch cover. Both surfaces
must be clean to ensure adhesion of the silicone
sealant.
5. Install and properly align the inner clutch cover. Be
sure the cables and hose routings are correct.
6. Install the four inner clutch cover bolts and washers
that retain the cover to the transmission. Torque bolts
to specification.
7. Install the four inner clutch cover bolts and washers
that retain the cover to the engine. Torque bolts to
specification.
TORQUE
PVT Inner Clutch Cover Bolts:
12 ft-lbs (16 Nm)
8. Clean the splines inside the driven clutch and on the
transmission input shaft.
9. Apply a light film of grease to the splines on the
shaft.
10. LE Model: Install the driven clutch assembly, washer
and retaining bolt. Torque to specification.
PVT SYSTEM

Polaris RZR 570 2015 Specifications

General

Brand	Polaris
Model	RZR 570 2015
Category	Offroad Vehicle
Language	English