5.10
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
11. BASE and INTL Models: Install the inner clutch
sheave, thrust washers (3) and, noting clutch sheave
orientation, outer clutch sheave. Torque retaining
bolt to specification.
TORQUE
Driven Clutch Retaining Bolt:
36 ft-lbs (49 Nm)
12. Clean the end of the taper on the crankshaft and the
tapered bore inside the drive clutch.
13. Install drive clutch onto the engine and torque
retaining bolt to specification.
TORQUE
Drive Clutch Retaining Bolt:
47 ft-lbs (64 Nm)
14. Install the drive belt noting direction of belt rotation
(see Chapter 6 – Belt Installation, page 5.12). If a
new belt is installed, install so numbers can be easily
read.
15. Install a new outer clutch cover seal with the colored
stripe facing the inner clutch cover.
16. Reinstall outer clutch cover and secure with bolts.
Torque bolts to specification.
TORQUE
PVT Outer Clutch Cover bolts:
50 in-lbs (5 Nm)
17. Install the clutch inlet and outlet ducts and tighten the
hose clamps.
TORQUE
Wheel Nuts:
Steel Rims: 27 ft-lbs (37 Nm)
Aluminum Rims: 30 ft-lbs (41 Nm) + 90°
18. Reconnect the battery cable.
19. Install engine service panel and both seats.
PVT SYSTEM
To Next Page
Loading...
Need help?
General
