6.8
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
18. Remove the four fasteners securing the rear bolt in
brace to the vehicle main frame. Maneuver the brace
forward for transmission removal clearance. Note the
routing of the transmission breather hose and wire
harness.
19. Remove the clip and washer (D) securing the shift
cable to the bell crank.
20. Remove the two fasteners securing the transmission
shift bracket (E) to the transmission case. Swing
assembly clear of the main frame for transmission
removal.
21. Disconnect the vehicle speed sensor (F) and gear
position switch (G) harness connectors. Cut tie strap
(H). Note harness routings for reassembly.
22. Remove the transmission vent tube (I).
23. INTL - Remove the parking break cable and asm.
24. Remove and discard the four rear brake caliper
mounting bolts on the RH and LH side as outlined in
Chapter 7 and 9.
CAUTION
Do not hang the caliper by the brake line. Use wire to
hang caliper to prevent damage to the brake line.
25. Remove the four rear upper and lower A-arm to
bearing carrier bolts, nuts and washers from the RH
and LH side as outlined in chapter 7.
26. With a short, sharp jerk, remove the rear drive shaft /
bearing carrier assemblies from the vehicle as
shown.
TRANSMISSION
To Next Page
Loading...
Need help?
General
