6.44
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
6. Inspect the pinion shaft assembly. Replace bearings
if needed. Inspect each gear for damage, chips or
abnormally worn teeth.
NOTE
If pinion shaft was disassembled, the bearing cover
must be installed on the shaft before installing the 46T
gear.
7. Install the pinion shaft assembly. Be sure to properly
mesh the snorkel shaft bevel gear with the pinion
shaft bevel gear.
8. Apply Loctite
®
242
™
to the threads of the bearing
cover retaining screws.
9. Using a 5 mm Allen wrench, install only the three
screws that secure the pinion shaft assembly as
shown below. Leave the longer locking screw (A) out
at this point.
NOTE
DO NOT install the longer screw (A). Installing the
longer screw will lock the snorkel tube and not allow for
backlash setting adjustment.
10. Torque the bearing cover retaining screws to
specification.
TORQUE
Bearing Cover Retaining Screws:
8 ft-lbs (11 Nm)
11. Rotate the snorkel tube counterclockwise using the
snorkel tool (PA-50231) until the snorkel gear and
pinion gear have ‘zero’ backlash.
NOTE
DO NOT overtighten the snorkel tube when backing it
out. At the 'zero' backlash position, you should still be
able to turn the snorkel shaft using your fingers, but it
will feel rough and may have some tight spots.
12. Look down into the transmission housing to see the
snorkel locking screw hole opening to reference your
starting point.
NOTE
If you have a hard time seeing into the hole, insert a
small Allen wrench, punch or screwdriver into the hole
to feel when the notch is aligned with the hole.
TRANSMISSION
To Next Page
Loading...
Need help?
General
