Polaris RZR PRO XP 2021 User Manual

2.48
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
WHEEL TOE ALIGNMENT INSPECTION
1. Place machine on a smooth level surface and set
steering wheel in a straight ahead position. Secure
the steering wheel in this position.
2. Place a chalk mark on the center line of the front tires
approximately 10″ (25.4 cm) from the floor or as close
to the hub/axle center line as possible
q
.
NOTICE
It is important the height of both marks be equally
positioned to get an accurate measurement.
3. Measure the distance between the marks and record
the measurement. Call this measurement
w
.
4. Rotate the tires 180° by moving the vehicle forward.
Position chalk marks facing rearward, even with the
hub/axle center line.
5. Measure the distance between the marks and record.
Call this measurement
e
. Subtract measurement
e
from measurement
w
, this is the vehicle toe. Toe-out
means the measurement at the front of the tire
w
is
wider than the measurement at the rear
e
. Toe-in is
just the opposite.
MEASUREMENT
Wheel Toe:
1/4” (6.35 mm) toe-in – 1/4” (6.35 mm) toe-out
MAINTENANCE

Polaris RZR PRO XP 2021 Specifications

General

Brand	Polaris
Model	RZR PRO XP 2021
Category	Offroad Vehicle
Language	English