3
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
3.49
34.Remove fasteners
2!
and washers
2@
retaining inner
cover to transmission.
35.Discard PVT inner cover o-ring around the crankshaft
snout.
36.Remove fasteners
2#2$
retaining engine to the engine
mount bracket.
37.Lift engine out of the chassis, be careful not to snag
any hoses or wiring.
38.If replacing engine: remove applicable coolant
hoses, stator/flywheel, starter and engine sensors.
ENGINE INSTALLATION
1. If removed from engine: install applicable coolant
hoses, stator/flywheel, starter and engine sensors.
2. Install engine in the chassis, be careful not to snag
any hoses or wiring.
3. Install fasteners retaining engine to the engine mount
bracket. Torque fasteners to specification.
TORQUE
Engine Mounting Bracket Fasteners:
42 ft-lb (57 Nm)
4. Loosely install fasteners retaining inner cover to the
transmission and engine/trans joint.
5. Loosely install the three allen screws
2!
and washers
2@
retaining inner cover to engine.
ENGINE / COOLING SYSTEM
To Next Page
Loading...
Need help?
General
