Polaris RZR PRO XP 2021 User Manual

6
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
6.37
7. Install the stationary and movable sheave on the
vehicle. See Driven Clutch Installation.
DRIVEN CLUTCH INSTALLATION
1. Install the driven clutch on the transmission input
shaft.
2. Install shim
q
, washer
w
, and driven clutch retaining
bolt
e
. Torque bolt to specification.
TORQUE
Driven Clutch Retaining Bolt:
43 ft-lbs (58 Nm)
3. With the clutch spreader tool installed, loop the belt
over the drive clutch and over part of the driven
clutch. Be sure to install belt in the direction
previously marked.
4. Rotate the driven clutch and walk the belt into the
clutch.
5. Remove the clutch spreader tool from the driven
clutch.
6. Rotate / spin the driven clutch and belt approximately
5-7 times to properly seat the belt in the driven clutch.
7. Install the outer clutch cover and fourteen fasteners
r
. Torque fasteners to specification.
TORQUE
Outer Clutch Cover Fasteners:
36 in-lbs (4 Nm)
PVT SYSTEM

Polaris RZR PRO XP 2021 Specifications

General

Brand	Polaris
Model	RZR PRO XP 2021
Category	Offroad Vehicle
Language	English