3.18
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
HEAD PIPE / TURBO REMOVAL
1. Remove the exhaust pipe. See Exhaust Pipe
Removal page 3.16 outlined in this chapter.
2. Remove two P-clip fasteners retaining the oil feed line
to the turbo bracket assembly.
3. Remove two hoses
q
from the turbo going to the
boost control valve. Mark hoses for correct
reinstallation to the boost control valve.
4. Remove the banjo bolt
w
retaining the oil inlet hose
and remove the oil drain hose
e
.
CAUTION
Use caution when removing oil feed line to avoid
bending/damaging the hard line.
IMPORTANT
The oil line sealing washers MUST be replaced any
time the oil line/fitting is removed. Use only the
recommended washers shown in the Polaris Electronic
Parts Catalog.
5. Remove two fasteners
r
and remove the coolant
inlet hose
t
and outlet hose
y
.
6. Remove two fasteners
u
retaining turbo bracket to
the turbo.
7. Loosen four fasteners
i
on the engine mounting
bracket and pivot the top of the turbo bracket forward.
8. Remove two fasteners
o
and remove the lower turbo
heat shield.
ENGINE / COOLING SYSTEM
To Next Page
Loading...
Need help?
General
