Poly P025 Administrator's Guide

Manually Pair an IP Device
If you turn off automatic pairing of link-local network (LLN) connections, you must manually pair an IP device to use it with
your system.
Know the MAC address of the device you’re pairing.
Task
1 Connect the device to an LLN port on the back of your system.
2 In the system web interface, go to General Settings > Device Management.
3 Under Available Devices, find the device by its MAC address (for example, 00e0db4cf0be) and select Pair.
If paired successfully, the device displays under Connected Devices with a Connected status. If a device shows a
Disconnected status, this indicates that pairing wasn’t successful.
Pairing IP Devices on the Local Area Network (LAN)
Supported IP devices can pair to your video system over your primary local area network (LAN).
Pairing a Poly Trio
You can use a Poly Trio system as a controller and audio device with a G7500 or Studio X Family video system. See your
system’s latest
Release Notes for supported Poly Trio models.
Note: Poly G7500 and Studio X Family video systems support pairing up to two Poly Trio systems.
Zoom Rooms is the only third-party conferencing application supported in this setup.
This setup is supported while using the following third-party conferencing applications:
• Zoom Rooms
• Microsoft Teams (except G7500 systems)
You pair the phone as an IP device over your primary network. When paired, from the video system web interface you can
configure audio to play from the phone speakers, Studio X Family system speakers, or monitors connected to the video
system. The Poly Trio microphones are always on.
Configure a Poly Trio for Pairing
To pair with a video system, you must configure your Poly Trio system’s base profile and device role.
Task
1 On the phone’s local interface, go to Settings > Advanced > Administration Settings > Network Configuration.
2 Set the Base Profile to Generic.
3 After the phone restarts, go to Settings > Advanced > Networked Devices.
4 Set Networked Device Role to Device.
The system automatically restarts.
Pair an IP Device on the Primary Network
Some devices connected to your primary network can pair with your video system. For example, this feature enables you
to pair a Poly TC 8 device without a physical connection to the video system.
Note: Pairing IP audio devices and cameras over the primary network isn’t supported.
To pair, the device must be on the same subnet as the video system and the following network components must be
unblocked:
• Multicast address 224.0.0.200
• TCP port 2000
• UDP port 18888
Know the MAC address of the device you’re pairing.
20

Poly P025 Specifications

General

Brand	Poly
Model	P025
Category	Conference System
Language	English