Poly P025 Administrator's Guide

Configure System VLAN Settings
You can configure your system’s virtual LAN (VLAN) settings.
Note: VLAN isn’t supported in IPv6 environments.
Task
1 In the system web interface, go to Network > LAN Network > LAN Options.
2 Optional: Select the Enable LLDP check box so that the system can advertise itself on the network using Link Layer
Discovery Protocol (LLDP).
If you enable LLDP and then enter a VLAN ID, the VLAN ID you enter supersedes the auto-discovered VLAN ID from
LLDP.
3 Select the 802.1p/Q check box and enter a VLAN ID.
You can use values from 1 to 4094.
4 Enter a Video Priority to set the link layer priority of video traffic on the wired LAN.
Video traffic is RTP traffic consisting of video data and associated RTCP traffic. You can use any value from 0 to 7,
although Poly recommends not using 6 and 7.
5 Enter an Audio Priority to set the link layer priority of audio traffic on the wired LAN.
Audio traffic is RTP traffic consisting of audio data and associated RTCP traffic. You can use any value from 0 to 7,
although Poly recommends not using 6 and 7.
6 Enter a Control Priority to set the link layer priority of control traffic on the wired LAN.
Control traffic consists of control information associated with a call:
• H.323: H.225.0 Call Signaling, H.225.0 RAS, H.245, Far-End Camera Control (FECC)
• SIP: SIP Signaling, FECC, Binary Floor Control Protocol (BFCP)
You can use any value from 0 to 7, although Poly recommends not using 6 and 7.
7 Select Save.
Configure System 802.1X Settings
You can configure your system to use 802.1X authentication when connecting to the wired LAN.
Install the PKI certificates on your system required for authenticating with your network.
Note: 802.1X isn’t supported in IPv6 environments.
The system supports the following authentication protocols:
• EAP-MD5
• EAP-TLS
• EAP-TTLS
– EAP-MSCHAPv2
– EAP-GTC
• EAP-PEAPv0 (MSCHAPv2)
– EAP-MSCHAPv2
– EAP-GTC
Task
1 In the system web interface, go to Network > LAN Network > LAN Options.
2 Select the Enable EAP/802.1X check box.
3 Select an EAP/802.1X authentication method.
4 Optional: For EAP-TTLS or EAP-PEAPv0, choose an EAP/802.1X Phase 2 Authentication.
37

Poly P025 Specifications

General

Brand	Poly
Model	P025
Category	Conference System
Language	English