Customizing the VSX System
4 - 21
Configuring StereoSurround Settings
To send or receive stereo audio, make sure your VSX system equipment is set
up as described in Connecting Microphones or a SoundStation VTX 1000 on
page 2-17 and Connecting Speakers on page 2-24. Then configure the system
to use Polycom StereoSurround, test the system configuration, and place a test
call.
If you are in a call with a far site that is sending audio in stereo mode, you can
receive in stereo. In multipoint calls where some sites can send and receive
stereo and some sites cannot, any site that is set up to send or receive stereo
will be able to do so.
To configure systems to send and receive Polycom StereoSurround:
Camera tracking is disabled when you enable StereoSurround.
Go to this screen: Configure these settings:
Audio
System > Admin Settings > Audio
Set Enable Polycom StereoSurround.
Audio Levels
System > Admin Settings > Audio >
Audio Settings > Next > Next
VSX 7000, VSX 7000s
Set Subwoofer Speaker to Off.
To Next Page
Loading...
Need help?
General
