Page 122
Remote Alarm
When a Modem is connected to, via the RS232 port, (Consult Pulsar or your
local distributor for further details), the following parameters are used to set
up the FlowCERT LITE so that when the level reaches a specific alarm
point, as determined by the setting of the relay(s) the unit will dial and
connect to a remote telephone number to provide details of the event.
P144 Call Type
This parameter determines what type of connection is made via the modem.
Remote alarm function is disabled
This option initiates a connection to a
remote modem/computer which will then
allow remote communication with the unit.
Please consult Pulsar or your local
distributor for further details.
This option initiates a predetermined
message which is sent to the remote
telephone number detailing date and time
the alarm was initiated, the site ID, alarm
condition and level at the time the alarm
was initiated.
P145 Tel. No.1
This parameter is used to enter the number of ‘0’s that appear at the
beginning of the telephone number to be dialled that is to receive the
message.
No ‘0’s present at the beginning of the
telephone number to be dialled.
1 ‘0’ present at the beginning of the
telephone number to be dialled.
2 ‘0’s present at the beginning of the
telephone number to be dialled.