Page 30
Chapter 4 Quick Setup Guide
This quick set-up guide shows you how to get up and running within a few
minutes of installing your FlowCERT LITE.
Enter Program Mode
First you need to go from run mode into program mode. Assuming the
passcode is the default 1997, then you should enter this.
Choose Quick Setup
Now you need to go into the quick setup. You will see on the display the
words ‘Quick Setup’, which is the first item on the menu system. Try
pressing either of the two arrow keys to see some more menu options, but
return to Quick Setup, and press
This takes you to the “Quick Setup Menu”.
This takes you to the common applications menu,
and a number of options will appear on the display.
Note
If you have already setup a common application, then there will be a
number shown other than 0, and you will see messages showing
what the current setup is. If you want to reset this and start again,
press 0 (which will reset all the quick setup parameters), otherwise
pressing ENTER will allow you to edit the parameters that have been
set.
To Next Page
Loading...
Need help?
General
