Pulsar FlowCERT LITE User Manual

Page 17
Maintenance
There are no user serviceable parts inside FlowCERT LITE, except the
mains fuse. If you experience any problems with the unit, then please
contact Pulsar Process Measurement for advice.
Important Information
Please note that the onboard Lithium battery, mounted to the
processor PCB, is not user serviceable.
To clean the equipment, wipe with a damp cloth. Do not use any solvents on
the enclosure.
Important Information
The unique DATEM software comes into operation as soon as
power is applied, and is designed to monitor a moving level or
target with the transducer in a fixed position.
If, after any period of use, it should become necessary to move the
transducer, for any reason, from its original operating position,
switch off the FlowCERT LITE, before proceeding, in order to
prevent any undesirable updates to the DATEM trace. If after
moving the transducer the reading is not as expected please refer to
Chapter 7 Troubleshooting.

Pulsar FlowCERT LITE Specifications

General

Brand	Pulsar
Model	FlowCERT LITE
Category	Measuring Instruments
Language	English