Qlogic SANsurfer FC HBA Manager User Manual

Getting Started
Specifying the Adapter Driver Settings
SN0054651-00 G 5-29
A
Figure 5-13 Shared Components Dialog Box
3. Click the shared device or LUN in the left column to view the shared hosts in
the right column.
4. To close the Shared Components dialog box and return to the Shared
Device Found dialog box, click OK.
5. To close the Shared Device Found dialog box, click OK.
When SANsurfer FC HBA Manager updates the configuration to reflect
configuration changes made by another host, the “configuration
change - reloading” message appears. Click OK.
Specifying the Adapter Driver Settings
When you set adapter driver parameters, specify the following:
 Target: Display Options. Indicates that only targets configured using
SANsurfer FC HBA Manager are seen by the system.
 Target Binding Options. Indicates that the driver binds the target ID using
the target's world wide port name (WWPN) or port ID.
NOTE:
If you are using the IOCTL module with inbox drivers in Red Hat 4.0, the
driver settings are disabled. The driver settings are also disabled if you are
using sysfs supported inbox drivers with SLES 10.0.

Qlogic SANsurfer FC HBA Manager Specifications

General

Brand	Qlogic
Model	SANsurfer FC HBA Manager
Category	Software
Language	English