Qlogic SANsurfer FC HBA Manager User Manual

Installing SANsurfer FC HBA Manager
Initial Installation
4-10 SN0054651-00 G
S
6. Select an install location using one of the following methods:
 To accept the destination location shown in the dialog box and
continue, click Next (recommended).
The default location for a Windows system is:
C:\Program Files\QLogic Corporation\SANsurfer
The default location for a Red Hat/SUSE Linux and Solaris
SPARC/x86 system is:
/opt/QLogic_Corporation/SANsurfer
 To select a different location:
a. Click Choose, and then select an installation location.
b. On the Choose Install Folder dialog box, click Next.
 If you selected a different location and want to reselect the default
location:
a. Click Restore Default Folder.
b. Click Next.
If there is a previous version of the SANsurfer tool on the system, the
Previous SANsurfer Install Detected message box appears (Figure 4-7).
Figure 4-7 Previous SANsurfer Install Detected Message
NOTE:
For NetWare, select the drive mapped to the NetWare server (always
select a location other than the default).

Qlogic SANsurfer FC HBA Manager Specifications

General

Brand	Qlogic
Model	SANsurfer FC HBA Manager
Category	Software
Language	English