Getting Started
Setting the Configuration Policies
5-26 SN0054651-00 G
S
If you select this policy and SANsurfer detects this type of
sharing, it displays a warning message. Do one of the following:
To disable access to these devices from other hosts that
display in the FC/CNA HBA tree, click OK.
To disable this policy for this instance, click Cancel.
To view which devices are being shared with hosts that are
conflicting with this policy, click More.
Configure the selected device and display a message if the
device is already configured on another host(s).
This policy configures the selected device and shows a message
if the device is configured on another host.
If you select this policy and SANsurfer detects this type of
sharing, it displays a warning message. Do one of the following:
To disable access to these devices from other hosts, click
OK.
To disable this policy for this instance, click Cancel.
To view which devices are being shared with hosts that are
conflicting with this policy, click More.
Ask these options when a device is configured and sharing
is detected.
If you select this policy and SANsurfer detects sharing, the
Shared Device Found dialog box (Figure 5-12) opens. Click one
of the following options:
Do not configure device.
Configure and disable access from other hosts.
Proceed with device configuration.
To accept your selection, click OK. To not configure the device,
click Cancel.
3. LUN sharing checking occurs each time a configuration change is made to a
LUN. On the Policy Settings dialog box (Figure 5-11) under Options for
sharing LUNs among host(s), complete the following:
To disable LUN sharing checking, clear the Check for shared
(enabled) LUNs among host(s) check box.
To enable device sharing checking, select the Check for shared
(enabled) LUNs among host(s) check box, and then select one of the
following policies:
To Next Page
Loading...
Need help?
General
