Appendix A Specifications
Power Specifications
LTO Ultrium 8-Slot Autoloader User’s Guide 51
Table 14 AC Power
AC Power Cord 1 The autoloader is shipped with a 7-foot (2.1-meter), three-conductor, 18
AWG power cord for 120 volt use in the United States and Canada, along
with an international adapter. The power cord has a molded NEMA 5-
15P male connector on one end and a molded IEC 320/EN 60320 female
connector on the other end. The power cord is UL Listed and CSA
Certified.
If you need an additional power cord, it must meet the following
specifications.
United States and Canada — 120 VAC Power Cord
1
• The power cord must have a molded NEMA 6-15P attachment plug
on one end.
• The power cord must have a molded EC 320/EN 60320 female
connector on the other end.
• The cordage must be an SJT or SVT type, 3-conductor, 18 AWG
minimum.
• The power cord must comply with local electrical code.
International — 230 VAC Power Cord
1
• The power cord must have a grounded attachment plug of the proper
type, rating, and safety approval for the intended country.
• The power cord must have an IEC 320/EN60320 female connector on
one end.
Input voltage 100 to 240 V AC ±10%,47 to 63 Hz
Power consumption:
Average while idle
Average while operating
Maximum while operating
Average heat output while
operating (based on the AC true
power consumption)
20 watts
35 watts
70 watts
119.4 BTU/hour
To Next Page
Loading...
Need help?
General