Quectel SG368Z Series User Manual

Smart Module Series
SG368Z_Series_Hardware_Design 41 / 113
4.1.1. Micro USB Interface
Only USB0_DP and USB0_DM are the system firmware burning interface. If you do not use this interface,
please be sure to reserve this interface and test points during the debugging and production process,
otherwise you will not be able to debug and produce burning firmware.
USB0_ID is internally pulled up to 1.8 V with an about 200 kΩ resistor.
USB0_VBUS is used to detect OTG mode and Device mode. It is active at high level. Its voltage range is
2.7– 3.3 V, and the typical value is 3.0 V. It is recommended to place a 100 nF capacitor near
USB0_VBUS
111
DI
USB0 insertion detection
Can not supply power for
peripherals.
A test point must be
reserved.
USB0_ID
118
DI
USB0 ID detect
Internally pull up to 1.8 V.
USB0_DP
112
AIO
USB0 2.0 differential data (+)
A test point must be
reserved.
USB0_DM
113
AIO
USB0 2.0 differential data (-)
A test point must be
reserved.
USB0_SS_TX_P
107
AO
USB0 3.0 transmit (+)
USB0_SS_TX_M
108
AO
USB0 3.0 transmit (-)
USB0_SS_RX_P
109
AI
USB0 3.0 receive (+)
USB0_SS_RX_M
110
AI
USB0 3.0 receive (-)
USB1_DP
79
AIO
USB1 2.0 differential data (+)
USB1_DM
83
AIO
USB1 2.0 differential data (-)
USB1_SS_TX_P
84
AO
USB1 3.0 transmit (+)
USB1_SS_TX_M
88
AO
USB1 3.0 transmit (-)
USB1_SS_RX_P
89
AI
USB1 3.0 receive (+)
USB1_SS_RX_M
92
AI
USB1 3.0 receive (-)
USB2_DP
289
AIO
USB2 2.0 differential data (+)
USB2_DM
292
AIO
USB2 2.0 differential data (-)
USB3_DP
295
AIO
USB3 2.0 differential data (+)
USB3_DM
297
AIO
USB3 2.0 differential data (-)

Quectel SG368Z Series Specifications

General

Brand	Quectel
Model	SG368Z Series
Category	Control Unit
Language	English