Notice:
1. If a user presses the
key when load is not present on the pan,
the message -Lo- will be indicated for a few seconds and the scale
will automatically return to weighing.
2. In order to comply with the rules of appropriate counting pieces put
as many pieces as possible during unit mass adjustment. Single
piece mass should not be less than 5 divisions.
3. If a single piece mass is lower than a reading interval d the display
will show the <Err5> message (see ch. 20. Error messages) and
short audible signal will be emitted than the scale returns to weighing.
Return to weighing:
• Press the
key twice.
15.4. +/- control referring to the inscribed standard mass
Procedure:
• Enter to <HiLo> function:
• The program enters the window of setting the lower threshold
of weighing (Min):
- 47 -
To Next Page
Loading...
Need help?
General
